-40%

DATAKOM DKG-116 Generator Manual and Remote Start Control Panel /Unit/Controller

$ 46.98

Availability: 69 in stock

Description

WE DO NOT SELL THIS PRODUCT TO USA AND CANADA
Check this Smartgen MGC100 replacement unit instead:
https
://
www
.
ebay
.
com
/
itm
/201830198871
DESCRIPTION
The Datakom DKG-116 is a low cost, comprehensive unit designed to start and stop a generating set both manually and remotely. The unit is suitable for both gasoline and diesel gensets. The standard unit controls gasoline engines. Diesel engine control is selected with a wire jumper connection. The manual control is made using
RUN
and
STOP
pushbuttons on the front panel.
The remote control is made via
REMOTE START
input signal. When the engine is running, the unit monitors fault conditions and shuts-down the engine automatically in the occurrence of an alarm. The alarms are identified by a group of LEDs displaying only the first occurring one. The
MENU
button select the display parameter scroll and allows program mode entry and lamp test functions.
The unit provides a set of digitally adjustable program parameters. All parameters are modified through front panel pushbuttons.
The
FUEL
output is programmable for
‘Activate to start’
or
‘Activate to stop’
solenoids. The optional auxiliary output may be programmed for alarm, choke, preheat or stop functions. The total engine run hours is kept in a tamper-proof non-erasable memory which is not affected by power failures. An optional MPU input is provided for fast crank cutting. The unit is designed for front panel mounting. Connections are made with 2 part plug and socket connectors.
The unit is only available in 12V version.
MEASUREMENTS
Generator Volts: L1-N, L2-N, L3-N
Generator Volts: L1-L2, L2-L3, L3-L1
Generator Frequency
Battery Voltage
OPTIONS
Auxiliary output (negative pulling).
PROGRAMMING
Both
High Temperature
and
Emergency Stop
inputs must be connected to
Battery negative
prior to enter the programming mode.
The program mode is entered by long-pressing the MENU  button.    Each  depression  of  the  MENU button will switch to the next parameter.
Another  long  press  will  enable  lamp  test  mode. Another  press  on  MENU  button  will  return  the display to normal mode.
Below parameters can be set as required:
AC voltage low limit:
70 to 500 VAC (Ph-N)
AC voltage high limit:
70 to 500 VAC (Ph-N)
MPU crank-cut frequency / 4:
0-1000Hz
Nominal frequency:
0=50Hz 1=60Hz
Oil switch type:
0=oil pressure 1=oil level
Fuel  relay  function:
0=Activate  to  start  1=activate to stop.
Auxiliary  relay  function:
0=Alarm,  1=choke, 2=stop, 3=preheat.
Choke timer:
0 to 15 sec.
Number of phases:
0=1ph 1=2ph 2=3ph 3=3ph
TECHNICAL SPECIFICATIONS
Alternator voltage:
15 to 300 V-AC (Ph-N)
Alternator frequency:
50 or 60 Hz nominal.
Measurement Accuracy:
0.5% + 1 digit
Overspeed:
nominal frequency + 14%  (+24% overshoot)
Underspeed:
30 Hz
Crank time:
10 sec.
Crank rest:
10 sec.
Crank attempts:
3
Stop timer:
10 sec.
Cooldown timer:
30 sec.
Holdoff timer:
10 sec.
DC Supply Range:
9.0 to 16.0 V-DC
Cranking dropouts:
survives 0 V for 100ms.
Typical Standby Current:
12 mA-DC (display off)
Maximum Operating Current:
130 mA-DC
Fuel and Crank outputs:
10A @ 12V-DC
Auxiliary Output:
1A @ 12V-DC (negative pulling  protected semiconductor output)
Operating temp.:
-40°C (-40°F) to 80 °C (176°F).
Maximum humidity:
95% non-condensing.
Dimensions:
102 x 55 x 40 mm (WxHxD)
Panel Cut-out Dimensions:
92x44 mm minimum.
Packed weight:
140 g
Case Material:
High Temp. ABS/PC (UL94-V0)
IP Protection:
IP65 (front panel), IP30 (rear)
Conformity (EU directives)
2006/95/EC (low voltage)
2004/108/EC (EMC)
Norms of reference:
EN 61010 (safety requirements)
EN 61326 (EMC requirements)
See also:
WR433-01 Generator Wireless Remote Control Receiver
WT433-02 Generator Wireless Remote Control Transmitter
WC433-21 Generator Wireless Remote Control Set
---------------------------------------------------------------------------------------------------------------
Check out
my
other items
for generator sets:
J1939 Communication Units
Synchronization Units
Automatic Mains Failure Units
Remote Start Units
Manual Start Units
Automatic Transfer Switches
Battery Chargers
Alternator Voltage Regulators
Panel Measurement Units
Earthquake Units
Telecommunication Units
Extension Units
---------------------------------------------------------------------------------------------------------------
We have a long time experience in international sales
and make delivery only with traceable service.
--------------------------------------------------------------------------------------------------------------
Other datakom products on
www.controllers4generators.com
--------------------------------------------------------------------------------------------------------------
ALL CUSTOMS FEES IN COUNTRY OF DESTINATION ARE UNDER BUYER'S  RESPONSIBILITY